SYVECS | X10 Gen2 Expander

£840.00 GBP
inkl. MwSt. Versand wird beim Checkout berechnet

Abholung bei Dream Automotive verfügbar

Gewöhnlich fertig in 24 Stunden

 

The Syvecs X10 expander is a very powerful device for controlling additional I/O (Inputs and Outputs) in an automotive electrical installation. With the use of two CAN controllers, the X10 communicates with master devices to behave as a slave for it, offering the entire I/O complement to its master device.  All our ECU’s (engine control units) will communicate with the X10 with just the use of 2 wires and we have also incorporated logic to allow other manufacturers to be able to work with the X10 as well.

4 of the outputs on the X10 are designed to be driven to a high load or low load, making them extremely flexible in what they can offer. These h-bridge outputs can be paired to control external DC motors which are used in drive-by-wire applications or many other automotive applications.

6 low-side outputs which drive the outputs to the ground are also useful for driving solenoids, relays, and external devices. These outputs also have the ability to have internal pull-up and fly-back diodes set.

4 DAC (digital-to-analog) outputs are also present that converts a binary input number into an analog voltage output. These outputs are useful for sending out a voltage to an external device to mirror a sensor signal for example.

While the X10 has 10 inputs not all of them share the same capabilities. 6 of the inputs (AS Inputs) are fully flexible and support frequency detection, SENT decoding, Thermistor (internal 3k pull-up), and bipolar operation which means the voltage is monitored above and below the reference ground for use with VR Sensors. The remaining 4 inputs are standard 0-5v ADC inputs.

To finish off the serious I/O compliment that the X10 offers, are 2 x NTK Lambda sensor circuits which allow a sensor to be connected directly and output the oxygen ratio via CAN to the master device.

TECH SPECS

    Outputs
    • 4 Half Bridge Outputs (Support: Full Bridges, Lowside or HighSide Drive)
    • (15Amp Peak (100ms) 8Amp Continuous)
    • 6 Low Side Outputs
    • (12Amp Peak (100ms) 6Amp Continuous)
    • 4 DAC Outputs (-5v to 5v)

    Inputs

    • 6 Flexible Inputs supporting frequency, Sent, thermistor, bipolar
    • 4 ADC Voltage inputs
    • 2 NTK Lambda Inputs
    Interfaces
    • USB For Updates and Configuration
    • 2 x CAN 2.0B interface for communication with other controllers or logging systems
    • 1 x Kline Interface
    Power Supply
    • 6 to 26V input voltage range
    • Ignition Switch Logic with high current supply
    Physical
    • IP67 Sealed in Automotive Spec -40c to 125c
    • 2 x 34 way Superseal 1.0 connectors
    • 150mm x 150mm

    FITTING DETAILS

    Dream Automotive offers in-house fitting on all products at our workshop in Luton, Bedfordshire. 

    AVAILABILITY

    2-15 DAYS

    Produktinformation